Easy Polar Bear Cookies
These Easy Polar Bear Cookies can be made with a few simple steps. They have a soft powdered sugar glaze and minimal royal icing details to keep them soft to bite.
Servings 12 cookies (approx.)
Equipment
- 2 ¼-inch wooden dowel rods
- 1 Rolling Pin
- 1 bear cookie cutter
- disposable piping bags
- Plastic tip coupler
- small round piping tip, such as #2 and #5
Ingredients
- 1 batch cookie dough from your favorite shortbread cookie or cut out sugar cookie recipe see note
For the Icing Glaze.
- 2 cups powdered sugar
- ¼ cup milk
- ½ teaspoon clear vanilla extract or other clear extract like almond, rum or coconut
For Decorating:
- Easy Royal Icing see note
- white sparkling sanding sugar Great Value brand recommended
- black royal icing powder or black food coloring gel
Instructions
Bake the Cookies:
- Preheat oven to 350°F or temperature indicated in your chosen cookie dough recipe. Line 2 cookie sheets with parchment paper.
- Flour a cutting board or mat. Roll the dough out to ¼-inch thickness. It is helpful to use ¼-inch diameter wooden dowel rods on each side of the dough as guides for the rolling pin to ensure an even thickness.
- Cut the dough with a bear cookie cutter.
- Place the cut dough shapes on parchment paper lined cookie sheets. Bake the cookies, one tray at a time, for 5-7 minutes, until baked through but not brown.
- Remove cookie sheet from the oven and allow cookies to cool for 1 to 2 minutes before removing them to a wire rack, then cool completely before glazing.
Glaze the Cookies:
- Place a wire rack over a parchment or waxed paper lined cookie sheet or work surface.
- Mix together the powdered sugar, milk, and extract. Using clear extract will keep the color of the icing white. Stir the icing together with a small spatula to avoid introducing bubbles. You can let the icing sit for a minute so bubbles rise and then pop them with the spatula. You can add more milk or powdered sugar to achieve a dippable consistency.
- Brush on the glaze with a silicone pastry brush or turn the cookie over and dip into the glaze, allowing the excess to run off. Use the brush or a toothpick to pop any bubbles.
- Allow the glaze to dry before adding the royal icing.
Add the Royal Icing Outline:
- Mix up outline consistency royal icing. Add the icing to a disposable piping bag fitted with a small round tip, such as a #2 or #5.
- Pipe the outline of the bear and an oval snout. You can make the outline around the ears thicker to define the outer ear versus inner ear. Immediately after piping, sprinkle white sparkling sanding sugar onto the wet icing so it will stick.
- Allow the icing to dry, then shake or brush off the excess sanding sugar.
Add the Final Details:
- Mix up the black royal icing to outline consistency and place it in a disposable piping bag. Snip off a very small opening and push some icing through onto a paper towel to make sure the icing is ready to pipe.
- Pipe on two eyes, a nose, and the paws. While actual polar bears have 5 toes, you may only be able to fit 4.
- Allow the royal icing to dry completely before storing.
Notes
Cut Out Sugar Cookies recipe HERE
Shortbread Cookies recipe HERE
Easy Royal Icing recipe HERE
Store the cookies in a single layer in an airtight container at room temperature. If you need to stack them, use a piece of aluminum foil to separate the layers to prevent grease transfer from underneath the top cookie onto the design of the bottom cookie.
You're Gonna Bake It After All
bakeitafterall.com